Fine Dolls House Miniatures by JS Miniatures

 

3 volt Coin Cell Battery Holder & Switch

3 volt Coin Cell Battery Holder & Switch Image
Detail Image

A very easy way to power our 3 volt LEDs.
Works with the common cr2032 coin cell battery (Not included)
Fully wired.
Comes with a small on/off switch.
Battery holder dimensions: 24mm wide x 25mm long x 6mm thick.

***Please Note: I'm very sorry but due to Royal Mail Regulations coin cell batteries can no longer be sent through the post so a battery can no longer be included with your order. Alkaline batteries (AAA, AA etc) are unaffected. Price has been reduced accordingly****

Capable of powering from 1 to 5 LEDs though the more LEDs you have the quicker the battery will drain and the less bright the LEDs will be.
For better results check out our AAA battery option

How to connect the battery holder to your LEDs

It is very easy. Just connect the red wire to the red wire and black wire to black wire.
The best way to do this is to solder the wires together and cover the joins with heat shrink tubing but if you're not a dab hand with a soldering iron just twist the wires together and protect the join with either electrical tape or heat shrink tubing.
2 x 1 inch pieces of 2.4mm heat shrink tubing will be supplied with your battery holder and additional lengths can be bought here: Shrink Tubing

Products

For a more reliable connection for larger numbers of LEDs we recommend using a connector block. Simply twist the wires together as before and place under the screw. Tighten the screw to secure and attach the battery wires opposite the corresponding LED wires. A connector block will also be supplied with your battery holder.

Products

Your Price:£3.45
10